FRETS.NET

Murray MacLeod's Discussions (110)

Discussions Replied To (109) Replies Latest Activity

"When I needed a custom length dual-action truss rod for a 13 fret guitar, I ordered…"

Murray MacLeod replied Jul 8, 2015 to Truss rod suppliers

7 Jul 8, 2015
Reply by Murray MacLeod

"I agree totally with your point about truss rod terminology, Paul.  Alas, so many pe…"

Murray MacLeod replied Jul 7, 2015 to Are neck jigs necessary?

97 Sep 17, 2015
Reply by steven gallagher

"" Not quite dead flat but I'm not sure how I could have accomplished this any other…"

Murray MacLeod replied Jul 7, 2015 to Are neck jigs necessary?

97 Sep 17, 2015
Reply by steven gallagher

"So how long does a thread have to remain dormant  before the addition of a fresh pos…"

Murray MacLeod replied Jul 6, 2015 to Are neck jigs necessary?

97 Sep 17, 2015
Reply by steven gallagher

"I'll put up a couple of pics  either tomorrow or Sunday, but I will say that if I we…"

Murray MacLeod replied Jan 23, 2015 to Tele lost mojo after neck tilted .

12 Jan 24, 2015
Reply by Andrew

"Len, a full length parallel shim could be made, but  there was no need for a shim on…"

Murray MacLeod replied Jan 23, 2015 to Tele lost mojo after neck tilted .

12 Jan 24, 2015
Reply by Andrew

"It's years since I did a neck with this, Mike,  but I'll look the jig out this weeke…"

Murray MacLeod replied Jan 22, 2015 to Tele lost mojo after neck tilted .

12 Jan 24, 2015
Reply by Andrew

"I made up a jig many years ago to solve this very problem in telecasters. Instead of…"

Murray MacLeod replied Jan 22, 2015 to Tele lost mojo after neck tilted .

12 Jan 24, 2015
Reply by Andrew

"I wouldn't use a plate joiner in this situation, not that it would do any harm, but…"

Murray MacLeod replied Nov 24, 2014 to Some advice on glues for a large break?

16 Nov 29, 2014
Reply by Mark Pollock

"Mike, let's try viusualising this geometrically instead of arithmetically or algebra…"

Murray MacLeod replied Nov 23, 2014 to So.. where's my math error?

44 Nov 23, 2014
Reply by Ned Knepp

RSS

© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service