FRETS.NET

Thomas James's Discussions (607)

Discussions Replied To (556) Replies Latest Activity

"I have run into this several times. Replace the bolt and tightening solved the probl…"

Thomas James replied Jan 11, 2022 to Martin bolt-on with no bolt .

3 Jan 11, 2022
Reply by Len Biglin

"American-Carbide. & Microcut"

Thomas James replied Oct 4, 2021 to Dremel Routing Fret Slots

41 Nov 16, 2021
Reply by Frank SIlano

"George, thank you for the detailed info on your clamping jig solution.  I will give…"

Thomas James replied Jan 29, 2021 to Awkward crack

15 Apr 9, 2021
Reply by Taffy Evans

"Have you humidified the guitar to see if it will close ?"

Thomas James replied Jan 14, 2021 to top seem

7 Jan 30, 2021
Reply by Colin O'Brien

".055 x .095 inches."

Thomas James replied Jan 12, 2021 to Narrow - tall frets on American Pro 11 strat .

2 Jan 12, 2021
Reply by Len Biglin

"Looking at an older chart on a Dunlop Accu-Fret box. It shows #6350 with a .070 widt…"

Thomas James replied Dec 21, 2020 to Fret wire .070 wide

5 Dec 21, 2020
Reply by Thomas James

"We use a lot of StewMac wire, so we have empty ones to re -use. Also, cardboard tube…"

Thomas James replied Dec 9, 2020 to Fret wire/pieces storage ideas

6 Dec 17, 2020
Reply by Brian Stewart

"Straight pieces in tubes. Left over bend pieces; I cut those into short lengths and…"

Thomas James replied Dec 8, 2020 to Fret wire/pieces storage ideas

6 Dec 17, 2020
Reply by Brian Stewart

"I have always glued the shims to the neck tenon then adjust the fit."

Thomas James replied Dec 4, 2020 to Question about neck dovetail shims

9 Dec 14, 2020
Reply by onewent

"We have six routers. The Bosch Colt get the most use because of its size."

Thomas James replied Dec 4, 2020 to Router Recommendation

6 Dec 5, 2020
Reply by mr smits

RSS

© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service