Split Saddle Adjustment Q - FRETS.NET2024-03-28T19:39:31Zhttp://fretsnet.ning.com/forum/topics/split-saddle-adjustment-q?feed=yes&xn_auth=noNo problem.tag:fretsnet.ning.com,2018-02-08:2177249:Comment:1767622018-02-08T01:00:08.407ZAndrewhttp://fretsnet.ning.com/profile/Andrew715
<p>No problem.</p>
<p>No problem.</p> Thanks for the reply, Andrew.…tag:fretsnet.ning.com,2018-02-07:2177249:Comment:1768562018-02-07T17:45:32.210ZGordonhttp://fretsnet.ning.com/profile/Gordon789
<p>Thanks for the reply, Andrew. That's what I figured as well. The radius is right and the E & B saddle is fine. I just need to work from the low E to G.</p>
<p>Thanks for the reply, Andrew. That's what I figured as well. The radius is right and the E & B saddle is fine. I just need to work from the low E to G.</p> If you want to work from the…tag:fretsnet.ning.com,2018-02-07:2177249:Comment:1768532018-02-07T16:41:46.566ZAndrewhttp://fretsnet.ning.com/profile/Andrew715
<p>If you want to work from the bottom, do the math on the amount of material you want to remove according to the twelfth fret action. Because there are two saddles, you (may) have to do that twice, using the e and g strings and the d and E strings. Otherwise just like a normal saddle. If only the bass side needs lowered then only do the bass side.</p>
<p></p>
<p>Of course this assumes the saddles' radius is already correct. </p>
<p>If you want to work from the bottom, do the math on the amount of material you want to remove according to the twelfth fret action. Because there are two saddles, you (may) have to do that twice, using the e and g strings and the d and E strings. Otherwise just like a normal saddle. If only the bass side needs lowered then only do the bass side.</p>
<p></p>
<p>Of course this assumes the saddles' radius is already correct. </p> Thomas,
Thanks for the reply.…tag:fretsnet.ning.com,2018-02-05:2177249:Comment:1766582018-02-05T21:21:11.288ZGordonhttp://fretsnet.ning.com/profile/Gordon789
<p>Thomas,</p>
<p>Thanks for the reply. These are already compensated so I'd rather take the material off the bottom. I know I can just get my measurement on the bass side and draw a line to nothing and then sand it. </p>
<p>Thomas,</p>
<p>Thanks for the reply. These are already compensated so I'd rather take the material off the bottom. I know I can just get my measurement on the bass side and draw a line to nothing and then sand it. </p> Use a radius gauge as guide.…tag:fretsnet.ning.com,2018-02-05:2177249:Comment:1765722018-02-05T19:44:24.066ZThomas Jameshttp://fretsnet.ning.com/profile/ThomasJames
Use a radius gauge as guide. Remove material from the top.
Use a radius gauge as guide. Remove material from the top.