Hi, chaps! Looking for cheaper alternative to the StewMac tang crimpers. Any ideas?

Views: 927

Reply to This

Replies to This Discussion

Make the tool yourself - that's what we ALL did years ago.  Here's an article I first  published on FRETS.COM more than two decades ago:

The photos are frame grabs from Hi-8 video tape, so they're low-res, but I think you can get what you need from them.

I'll have to do some looking, but there was a tool created that harnesses your Dremel and has a slot to feed the fret into the disk to trim the tang. 

Found it.


© 2023   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service