FRETS.NET

Paul Breen's Discussions (450)

Search Forum

View

Discussions Replied To (439) Replies Latest Activity

"Personally, with a Rosewood finger board, I would pull them normally. Maple finger b…"

Paul Breen replied Nov 27, 2023 to '68 Stratocster re-fret question

 4 Nov 30, 2023
Reply by Mark McCornack

"It's mineral staining (Iron) from not using Stainless steel. Oxalic acid, also known…"

Paul Breen replied Nov 27, 2023 to Remove staining on unfinished sides

 1 Nov 27, 2023
Reply by Paul Breen

"When I remove bridge plates, I first soak them with a damp to not quite fully wet sp…"

Paul Breen replied Oct 25, 2023 to Advice on removing massive added top reinforcement?

 5 Oct 25, 2023
Reply by Harry G Quattlebaum

"I was rather sure that you would not be inspired to build a screen. I was just sugge…"

Paul Breen replied Mar 1, 2023 to Rice glue

 8 Mar 4, 2023
Reply by charley erck

"Epoxy will release with heat. "

Paul Breen replied Feb 28, 2023 to During the neck re-set....

 4 Feb 28, 2023
Reply by Paul Breen

"Protein glues have been in use for 1,000's of years, I don't think there is much lef…"

Paul Breen replied Feb 28, 2023 to Rice glue

 8 Mar 4, 2023
Reply by charley erck

"Applause... clap, clap, clap! You may not be totally satisfied with your work but yo…"

Paul Breen replied Jun 11, 2021 to Rotted binding on a Gretsch 6122

 13 Jun 12, 2021
Reply by Dave Richard

"Looks like this will be a job of patience and attrition, you have your hands full. I…"

Paul Breen replied Jan 18, 2021 to Rotted binding on a Gretsch 6122

 13 Jun 12, 2021
Reply by Dave Richard

"Those frets where not machined with barbs. They have been distressed by hand with a…"

Paul Breen replied Jan 17, 2021 to Old Frets - General Question

 4 Jan 18, 2021
Reply by onewent

"Thanks for your input Frank, I suspect it will remain a mystery. "

Paul Breen replied Dec 15, 2020 to K1 Mandocello... factory spliced neck?

 6 Dec 15, 2020
Reply by Paul Breen

RSS

Members

© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service