FRETS.NET

Can someone enlighten me? In my woeful ignorance, I've been doing fret jobs and setups for over 30 years WITHOUT a neck jig! Despite the fact that I have never had a dissatisfied customer, I have been told that I cannot perform a PERFECT fret job without paying Stew-Mac £230 + postage for four bits of wood, a few screws and a couple of dial gauges ....and a further £60 to British Customs, which I would bitterly resent! I know William Cumpiano is slightly scathing about neck jigs, I don't know what Frank Ford uses, but I don't think I have seen it mentioned in his pages.
The only advantage I can see is the "WOW!" factor, when the customer walks in the shop and thinks. "this guy's really hi-tec!". It pays to generate mystique!
Anyone care to set me straight?

Views: 12732

Reply to This

Replies to This Discussion

>> I built my steel guitar holder before I'd read anything on the internet about repair..

I didn't think steel guitars had frets.   :-)

RSS

© 2021   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service