FRETS.NET

Allan Lang's Discussions (20)

Search Forum

View

Discussions Replied To (18) Replies Latest Activity

"I'm in Philadelphia PA and there's are not many professional guitar builders, repair…"

Allan Lang replied Aug 18, 2013 to Overlayed bridge plate, effect tone...?

 17 Aug 18, 2013
Reply by Allan Lang

"I saw that plug cutter and filler device but for a one or two time use $160 is a lot…"

Allan Lang replied Aug 18, 2013 to Overlayed bridge plate, effect tone...?

 17 Aug 18, 2013
Reply by Allan Lang

" Hello Scott, You get the neck off the traditional way, removing the fret just pass…"

Allan Lang replied Aug 17, 2013 to Overlayed bridge plate, effect tone...?

 17 Aug 18, 2013
Reply by Allan Lang

"Ned,  boy you're on top of on the situation, good one. You are so correct. "From my…"

Allan Lang replied Aug 17, 2013 to Overlayed bridge plate, effect tone...?

 17 Aug 18, 2013
Reply by Allan Lang

"Thanks Mike I think I can make something like that in my shop, I have a lot of alumi…"

Allan Lang replied Aug 17, 2013 to Overlayed bridge plate, effect tone...?

 17 Aug 18, 2013
Reply by Allan Lang

"Thanks, for the link and yes I have a small hand held router. "Regarding the intonat…"

Allan Lang replied Aug 17, 2013 to Overlayed bridge plate, effect tone...?

 17 Aug 18, 2013
Reply by Allan Lang

"Thank you for replying Hesh, your comments all make sense. I had reset the neck when…"

Allan Lang replied Aug 16, 2013 to Overlayed bridge plate, effect tone...?

 17 Aug 18, 2013
Reply by Allan Lang

"Well they probably put that shim in at the factory, it is common practice to shim st…"

Allan Lang replied Jul 21, 2013 to Shimming Electric Bolt-On Necks?

 31 Jul 21, 2013
Reply by Paul Verticchio

"Ditto. Taylor has a nice 'thin' non-lacquer finish and their instruments sound fanta…"

Allan Lang replied Feb 22, 2013 to Spraying lacquer over poly....?

 24 Feb 26, 2013
Reply by Todd Mylet

"Hi Bill,  this Tokai has a very thick finish, to try to scrap it off and sand would…"

Allan Lang replied Feb 20, 2013 to Spraying lacquer over poly....?

 24 Feb 26, 2013
Reply by Todd Mylet

RSS

Members

© 2025   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service