FRETS.NET

Russell Vance's Discussions (1,232)

Search Forum

View

Discussions Replied To (1220) Replies Latest Activity

"Bob, I am familiar with Kamimotos procedure and consider his book to be one of the b…"

Russell Vance replied Jan 6, 2010 to Flattening a warped neck

 11 May 15, 2010
Reply by Pierre-Antoine Roiron

"Without wishing to offend: this is a valuable instrument that need proper repair: if…"

Russell Vance replied Jan 5, 2010 to Flattening a warped neck

 11 May 15, 2010
Reply by Pierre-Antoine Roiron

"I finish with 320 grade and then shoot a couple of coats before refretting to start…"

Russell Vance replied Jan 2, 2010 to i am looking for tips to start my maple finger board

 7 Jan 7, 2010
Reply by Donald A. Fortune

"We always replace harware and similar with commercial/genuine spares - the customer…"

Russell Vance replied Dec 25, 2009 to P-Bass Under Pickup Spring Foam ?

 10 Dec 26, 2009
Reply by Tom Krebs

"The part number is : Allparts: PU 6944-023 for bass pickup rubber sponge mounting st…"

Russell Vance replied Dec 23, 2009 to P-Bass Under Pickup Spring Foam ?

 10 Dec 26, 2009
Reply by Tom Krebs

"Take the two round threaded nuts, thread them onto the post and counter tighten them…"

Russell Vance replied Dec 17, 2009 to NASHVILLE STYLE ABR1 ? INSTALL

 1 Dec 17, 2009
Reply by Russell Vance

"For nitrocellulose I use water with a little dishwashing detergent added to hold and…"

Russell Vance replied Dec 16, 2009 to WD-40 for sanding, rub-out lubricant on finishes?

 7 Dec 16, 2009
Reply by FRANK

"Yep thanks for that Paul, there are a whole bunch of issues as to why you shouldn't…"

Russell Vance replied Dec 15, 2009 to Fender frets

 9 Dec 16, 2009
Reply by Paul Breen

"The pots (mainly CTS) I've pulled apart don't appear to be lubricated - loose pot ro…"

Russell Vance replied Dec 15, 2009 to how do manufacturers appropriately grease there pots for smoth action

 6 Dec 17, 2009
Reply by Rob Mercure

"Paul, conventionally installed frets have a diamond shaped cleat impressed in the fr…"

Russell Vance replied Dec 14, 2009 to Fender frets

 9 Dec 16, 2009
Reply by Paul Breen

RSS

Members

© 2025   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service