FRETS.NET

danove's Discussions (76)

Search Forum

View

Discussions Replied To (73) Replies Latest Activity

"During military service, I stayed the winter months far up north in Sweden. (at a ba…"

danove replied Nov 28, 2008 to Heat Stress? What about cold?

 15 Jan 28, 2009
Reply by Dave

"For a very beautiful finish you should consider french polishing and start of with a…"

danove replied Nov 27, 2008 to Finishing Curly Maple

 9 Nov 29, 2008
Reply by Russell Vance

"Frank has some good advice here Maybe you have to clean off the wax before proceedin…"

danove replied Nov 17, 2008 to What to do about white stuff In "dry creek bed" checked finish?

 4 Nov 24, 2008
Reply by Rick Homan

"I would shim that tongue to the top."

danove replied Nov 12, 2008 to Neck Angle Geometry

 15 Nov 15, 2008
Reply by Tim Mace

"You are welcome Jason. Do I understand you right - if I found replacement locking st…"

danove replied Nov 11, 2008 to What are these tuners worth?

 10 Nov 11, 2008
Reply by JasonG

"The long straight part on top of the control plate is 146.5 cm Center of ToM to cent…"

danove replied Nov 11, 2008 to What are these tuners worth?

 10 Nov 11, 2008
Reply by JasonG

"Mine has the smaller version control plate. Still seems to be a -73 Kalamazoo accord…"

danove replied Nov 11, 2008 to What are these tuners worth?

 10 Nov 11, 2008
Reply by JasonG

"The other solution is to lift the basside a bit higher towards the nut side. If my m…"

danove replied Nov 11, 2008 to Neck Angle Geometry

 15 Nov 15, 2008
Reply by Tim Mace

"In my opinion, there should not be any dip. Maybe acceptable on a cheap gear, but wh…"

danove replied Nov 11, 2008 to Neck Angle Geometry

 15 Nov 15, 2008
Reply by Tim Mace

"Thanks for the details Jason. Very interesting! I do like the original low impedance…"

danove replied Nov 11, 2008 to What are these tuners worth?

 10 Nov 11, 2008
Reply by JasonG

RSS

Members

© 2026   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service