Collings Fretboard Shaper

[Robert van der Linde]

The Collings fretboard shaper looks just like the tool I want to use in my workshop. Please, if anyone out there has pictures or drawings of this fantastic piece of equipment; mail me .

Thanks

[FRANK]

I use a belt sander glue it on and finalize it with a glass block and sand paper checking with a raidused gauge check out Grizzly and the sanders and attachments there is an attachment for a belt sander that is supposed to give best results

[Ron Frazier]

I have a swing arm that I attach the finger board wit vacuum than set it up to my sander and swing until I have it done. Works great.

Robro Ron

[FRANK]

I do mine by hand up on a belt sander and finalize it with a glass block

[Len Biglin]

What are these glass blocks ?Len

[FRANK]

Len I went to my local window installer tole him make me a block 11inches long 3 inches wide and 1/4 inch thick I use supper 77 3-m spray and glue on sand paper on both sides it works for sanding finger boards and frets Cheers PHB I also make my final shaping for nuts and begin to reduce my scratches in grit reduction so I have several blocks with different grits