FRETS.NET

I hope I'm not the first to think of this - I was scraping some drop fills on an archtop guitar and wanted to keep clear of the parts around the drop fill in the concave areas of the arch top..just bent a safety blade and taped the edges..

Tags: drop fills, scraper

Views: 895

Reply to This

Replies to This Discussion

Been doing this for years scraping touch ups, top crack splints, etc. I use "old style" razor blades and tape the edges on both sides at the same time. Some put a burr on the edge, like you do on scrapers, but I feel that these cheap thin Indian made razor blades have that burr already: you can always find which side scrapes better :)

Pre bending a blade? Cool...

I've always like grinding-off the corners before taping, just to help reduce the risk of "tilt n' scratch".  A few bad experiences proved to be a mighty good teacher :)

Interesting idea there to pre-bend the blade... I usually just flex it by hand while scraping to get a feel for the amount of curve, but you might be on to something there.   

Tensioning the curve is one less force I have to deal with while scraping , and I can adjust the depth of cut by angling the blade more or less, rather than deal with how much curve I'm applying to the blade. There's a constant arc that's adjusted by blade angle ;) I find it's easier..

I guess I've done this the other way around. I used to bend my into a curve after taping the ends but I stopped because I feel like I have better control if I flex it as needed.  In fact, I've found that I don't need the tape nearly as much because since the flex lifts the corners. My bench is littered with razor blades

RSS

© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service