FRETS.NET

Any 'easy' way to cut nice, thin, clean splines for filling cracks due to top shrinkage ?

I seem to remember buying a finish or veneer blade for the 8" table saw and setting a shallow angle, then ripping the 3/4" spruce only to within about 2" of the end of the board. (to keep it from becoming a projectile) However, the 10" saw I now have has tons o' blade wobble and I have no finish blade. As to the obvious, I have indeed  hydrated the mandolin in a plastic bag, but it has gone un-repaired for so long, the top will NOT close with any clamping pressure short of damage. Any quick ways of cutting "nice thin" spruce patching splines  before I resort to building a planing jig for spruce ?

Many thanks for any takers,
Paul

Tags: Making, for, repairing, splines, splits, top

Views: 140

Reply to This

Replies to This Discussion

Band saw with a fence then cut strips with a sharp knife?

You might cut them as narrow as you are able on your table saw then scrape them to thickness.

For short runs, like a mandolin, I might use a back saw and cut them by hand.

Ned
Thanks, sounds about right.

Paul
I've been using scrap top wood, and cutting off a piece the thickness of a saddle blank, to whatever length necessary. Then I sand a wedge into it using belt sander and final fitting with hand sanding on a flat slab of marble or granite.
Damn. I thought you were going to offer the method.
I didn't quite get your drift

RSS

© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service