FRETS.NET

Rick Hoey's Discussions (24)

Discussions Replied To (22) Replies Latest Activity

"I scratch the line with a sharp awl or exacto knife leaving an actual groove, which…"

Rick Hoey replied Jul 30, 2011 to Cutting nut slots accurately

24 Aug 6, 2011
Reply by Mark Pollock

"Probably a Tiple     http://www.youtube.com/watch?v=kODRy4VN6TA"

Rick Hoey replied Jul 1, 2011 to what's a 10 string uke called?

13 Jul 2, 2011
Reply by Ted Kritikos

"In Spanish building, at least the top is traditionally built using individual blocks…"

Rick Hoey replied Mar 19, 2010 to kerf continous or fully cut

10 Mar 28, 2010
Reply by Happy Builder

"Traditionally, maple boards are finished with nitrocellusose lacquer, but now often…"

Rick Hoey replied Jan 30, 2009 to Finishing finger boards ?

5 Feb 1, 2009
Reply by Tim Mace

"Works fine. Make sure there is no wax or oil on board and apply dye after the frets…"

Rick Hoey replied Jan 21, 2009 to ebony fingerboard dye

2 Jan 22, 2009
Reply by FRANK

"Paul, could you tell me the make and model of the instrument? Is this an active bass…"

Rick Hoey replied Jan 19, 2009 to hum active electronics ?

15 Feb 16, 2009
Reply by Ned Knepp

"Single coil pickups are always noisey, that's one reason humbuckers were invented, t…"

Rick Hoey replied Jan 19, 2009 to hum active electronics ?

15 Feb 16, 2009
Reply by Ned Knepp

"Steve, I read your first post and it seems to me you did everything right and all t…"

Rick Hoey replied Jan 14, 2009 to Meguiar's #9 Swirl Remover vs. SCRATCH X?

4 Jan 14, 2009
Reply by stevenrosburg

"Butyl Cellosolve is very nasty stuff. It works though. gloves and mask and good vent…"

Rick Hoey replied Jan 11, 2009 to where to find Butyl?

13 Jan 14, 2009
Reply by LennyBrooks

"thanks Tom. Simple and good. I should have come up with that. Must be getting old."

Rick Hoey replied Jan 2, 2009 to tusq pre slotted nuts

8 Jan 8, 2009
Reply by Darren

RSS

© 2022   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service