FRETS.NET

Thomas James's Discussions (594)

Search Forum

View

Discussions Replied To (544) Replies Latest Activity

"George, thank you for the detailed info on your clamping jig solution.  I will give…"

Thomas James replied Jan 29 to Awkward crack

 8 Feb 28
Reply by Chris Vallillo

"Have you humidified the guitar to see if it will close ?"

Thomas James replied Jan 14 to top seem

 7 Jan 30
Reply by Colin O'Brien

".055 x .095 inches."

Thomas James replied Jan 12 to Narrow - tall frets on American Pro 11 strat .

 2 Jan 12
Reply by Len Biglin

"Looking at an older chart on a Dunlop Accu-Fret box. It shows #6350 with a .070 widt…"

Thomas James replied Dec 21, 2020 to Fret wire .070 wide

 5 Dec 21, 2020
Reply by Thomas James

"We use a lot of StewMac wire, so we have empty ones to re -use. Also, cardboard tube…"

Thomas James replied Dec 9, 2020 to Fret wire/pieces storage ideas

 6 Dec 17, 2020
Reply by Brian Stewart

"Straight pieces in tubes. Left over bend pieces; I cut those into short lengths and…"

Thomas James replied Dec 8, 2020 to Fret wire/pieces storage ideas

 6 Dec 17, 2020
Reply by Brian Stewart

"I have always glued the shims to the neck tenon then adjust the fit."

Thomas James replied Dec 4, 2020 to Question about neck dovetail shims

 9 Dec 14, 2020
Reply by onewent

"We have six routers. The Bosch Colt get the most use because of its size."

Thomas James replied Dec 4, 2020 to Router Recommendation

 6 Dec 5, 2020
Reply by mr smits

"Review: The Green eBay Model (there are no markings on the vise) does the job. Howev…"

Thomas James replied Dec 3, 2020 to Parrot Vise

 3 Dec 3, 2020
Reply by Thomas James

"I did one of these a couple of months back. The pointy tip was loose. I ran some hid…"

Thomas James replied Oct 26, 2020 to SJ200 with rubbery guard that's loose .

 4 Oct 31, 2020
Reply by Len Biglin

RSS

Members

© 2021   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service