FRETS.NET

Mark Klossner's Discussions (12)

Discussions Replied To (9) Replies Latest Activity

"From what you're saying, the truss rod is working fine.  Before I did anything with…"

Mark Klossner replied Mar 15, 2015 to Relief problem after refret

12 Mar 16, 2015
Reply by Pim Boerdijk

"What is your action set at?  If your neck is straight, even with no relief it should…"

Mark Klossner replied Mar 15, 2015 to Relief problem after refret

12 Mar 16, 2015
Reply by Pim Boerdijk

"Thanks Mike.  I'm going to try it.  Hey Steve, I actually know someone whose garage…"

Mark Klossner replied Mar 14, 2015 to Oil finish for new necks

7 Mar 14, 2015
Reply by Mark Klossner

"Thanks Mike, I might just try that.  Were those instructions on the bottle of tru-oi…"

Mark Klossner replied Mar 14, 2015 to Oil finish for new necks

7 Mar 14, 2015
Reply by Mark Klossner

"They are mahogany necks, by the way. "

Mark Klossner replied Mar 13, 2015 to Oil finish for new necks

7 Mar 14, 2015
Reply by Mark Klossner

"I use a length of 1/4" or 5/16"semi-rigid plastic tubing.  Sometimes I tape a wire t…"

Mark Klossner replied Feb 26, 2015 to Regluing loose sides/kerfing on vintage Gibson, and how to place glue?

3 Feb 27, 2015
Reply by Dave Richard

"I feel the same.  I think .060 sounds like a winner.  Nice pictures, by the way.  I'…"

Mark Klossner replied Feb 18, 2015 to Top reinforcement on a D-18

8 Feb 18, 2015
Reply by Mark Klossner

"The bridge plate was split right down the middle.  It had a 1 5/8" maple bridge plat…"

Mark Klossner replied Feb 18, 2015 to Top reinforcement on a D-18

8 Feb 18, 2015
Reply by Mark Klossner

"Long time no see Alex.  This is more than just a cleat.  The bridge plate had split…"

Mark Klossner replied Feb 17, 2015 to Top reinforcement on a D-18

8 Feb 18, 2015
Reply by Mark Klossner

RSS

© 2022   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service