Forum Discussions (4,418)
| Discussions | Replies | Latest Activity |
|---|---|---|
Piezo Saddles (for tune-o-matics)has anyone here whacked one with a hammer to see what's inside? Looks like the actual saddle where the string rests is wrapped in something… Started by Penql in Luthier Talk |
3 |
Nov 28, 2008 Reply by Donald A. Fortune |
Ning IssuesI sent in a support ticket - nice that they allow users to report problems. Started by Penql in Luthier Talk |
1 |
Nov 27, 2008 Reply by Penql |
Pumice and RottenstoneI am at the final stages of my first guitar. I am just waiting for the KTM-9 brushed on water-based lacquer to cure before buffing. The tro… Started by Doug Collins in Luthier Talk |
10 |
Nov 24, 2008 Reply by Doug Collins |
Any thoughts on this repair?I am not going to take this repair on. But wanted to post it before it leaves shop. It is a Johnny Smith in a bad way. Braces are butchered… Started by Mike Fleck in Luthier Talk |
0 | Nov 24, 2008 |
What to do about white stuff In "dry creek bed" checked finish?The photo tells the story. The back of the headstock looks the same, and there is a little of this on sides at the upper bout, and a spot o… Started by Rick Homan in Luthier Talk |
4 |
Nov 24, 2008 Reply by Rick Homan |
Adjusting 60's D18 neck reliefI have a 1965 D18 on the bench for the well-known 'Top bulge at the bass side of the bridge' problem, plus minor intonation tweaks and acti… Started by Alys and Simcha in Luthier Talk |
5 |
Nov 23, 2008 Reply by David Reilly |
Making Forms for Fox/Universal SidebenderWhen I make a new form for my sidebender, I undersize it by the thickness of the sides, and usually have to touch up the bends on a hot iro… Started by Larry Schultz in Luthier Talk |
5 |
Nov 22, 2008 Reply by Larry Schultz |
neck reset due to humidity?I moved to the North Coast of the Dominican Republic and brought guitars, amps. Humidity here is very high, about 90 percent, and it is hot… Started by ken in Luthier Talk |
0 | Nov 21, 2008 |
Shellac BlushI have found several effective ways of chasing blush out of lacquer finishes, but I am having the devil's own time of chasing the blush fro… Started by Carter Ruff in Luthier Talk |
4 |
Nov 21, 2008 Reply by Greg Mirken |
Learning To InlayI would like to start the long process of learning the fine art of inlay and engraving. I had some inlay work done by Larry Robinson and ev… Started by tdibell in Luthier Talk |
4 |
Nov 21, 2008 Reply by Jerry Mercer |
© 2025 Created by Frank Ford.
Powered by
