FRETS.NET

Jeff Highland's Discussions (324)

Search Forum

View

Discussions Replied To (319) Replies Latest Activity

"Gee Hesh, Dont be so dismissive of the Martin neck joint, it's where all the tone co…"

Jeff Highland replied Jul 17, 2012 to Neck problem on a Martin 000-18

 26 Apr 14, 2013
Reply by Philip Warton

"No personal experince here but I would expect the additional bending monent from the…"

Jeff Highland replied Jul 7, 2012 to Resophonic necks?

 9 May 21, 2014
Reply by Mike Kolb

"In dificult cases  if you cut the saddle into 3 pieces so that each is only carrying…"

Jeff Highland replied Jun 13, 2012 to uneven strings volume on a Breedlove with L.R. Baggs piezo pick-up and preamp

 10 Jul 1, 2015
Reply by Russell Vance

"Perhaps the nut has been removed and not put back at some stage.If the rod is still…"

Jeff Highland replied Jun 8, 2012 to Fender Jazz Bass with truss-rod problem

 7 Jun 11, 2012
Reply by Eugen C

"A standard ABR-1 is 74mm centre to centre minus 4mm for stud diameter gives 70mm to…"

Jeff Highland replied Jun 7, 2012 to 1968 ES-335 / Gibson Bridge Question?

 6 Jun 7, 2012
Reply by Thomas James

"Perhaps originally  a  trapeze tailpiece with ABR-1 bridge with the small posts whic…"

Jeff Highland replied Jun 6, 2012 to 1968 ES-335 / Gibson Bridge Question?

 6 Jun 7, 2012
Reply by Thomas James

"I used a board clamped to my tablesaw with router attached for quite a few years."

Jeff Highland replied May 28, 2012 to Binding Maple neck

 17 May 28, 2012
Reply by Walter Morgan

"I would cut it on a router table with a binding cutter bit Basically a flush trim bi…"

Jeff Highland replied May 28, 2012 to Binding Maple neck

 17 May 28, 2012
Reply by Walter Morgan

"Probably better to cut channel, radius and SLOT first  before binding"

Jeff Highland replied May 28, 2012 to Binding Maple neck

 17 May 28, 2012
Reply by Walter Morgan

"Yes you would normally bind the edges of the fingerboard before installing it. Since…"

Jeff Highland replied May 27, 2012 to Binding Maple neck

 17 May 28, 2012
Reply by Walter Morgan

RSS

Members

© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service