Create a Ning Network!

Michael Lewis's Discussions (18)

View

Discussions Replied To (17)	Replies	Latest Activity
"Clean up hide glue with a damp rag. It might take a few minutes since it is dry now,…" Michael Lewis replied Feb 8 to Finish Stain (May Be Dried Hide Glue)	2	Feb 8 Reply by Michael Lewis
"Many of the old Harmonys had a piece of fret wire for the saddle of the bridge. You…" Michael Lewis replied Feb 8 to Harmony floating bridge	6	Feb 9 Reply by Doug Collins
"Man!!! I think you guys are over thinking this situation. Usually the area of the br…" Michael Lewis replied Feb 8 to New Bridge / Top Belly	24	Feb 16 Reply by Jim Bancroft
"For a bolt on neck for an instrument with F holes you need a l-o-n-g shaft with the…" Michael Lewis replied Feb 4 to My dovetail has been chopped off!	4	Feb 4 Reply by Michael Lewis
"You say there is movement, so can you get steam in there? I also think that a sectio…" Michael Lewis replied Feb 3 to Yamaha Gaki Neck reset	15	Feb 3 Reply by Ray Hughes
"Remove the fingerboard and install an adjustable truss rod. That would be a good opp…" Michael Lewis replied Feb 3 to non- adjutable truss rod	18	Feb 21 Reply by thefishinmusician
"If the break angle gets too low the tone and volume start to go away and the string…" Michael Lewis replied Feb 1 to Saddles questions...	6	Feb 1 Reply by Hann
"Have any of you seen inside one of these old Gibsons? This long bracing (end to end…" Michael Lewis replied Feb 1 to Gibson archtop guitar 7878	11	Feb 3 Reply by Ron Frazier
"If you are confident that you can make the neck so it will not need any adjustment t…" Michael Lewis replied Jan 31 to Graphite rod neck reinforcement	6	Feb 3 Reply by PAUL
"Titebond 3 front label says it is stronger but the back label in the instructions ca…" Michael Lewis replied Jan 31 to Why should I be not using Titebond lll	16	Aug 15 Reply by Markus Schmid

First
Previous
Next
Last
Page 1 of about 2

Welcome to
FRETS.NET

Sign Up
or Sign In

About

Frank Ford created this Ning Network.

Create a Ning Network! »

© 2009 Created by Frank Ford on Ning. Create a Ning Network!

Badges | Report an Issue | Privacy | Terms of Service

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use FRETS.NET.

Please check your browser settings or contact your system administrator.