FRETS.NET

Are there standard measurements for drilling co-ordinator rod holes in a Mastertone style rim?

Views: 82

Reply to This

Replies to This Discussion

From what I've seen, manufacturers do use slightly different measurements. The farther apart the rods, the more effective they are in adjusting neck angle, so I typically try to mount the upper rod as close to the tone ring as is reasonable, and deal with the lower rod the same way. As to the hole diameter, I use the smallest hole possible that still allows the rod to be inserted from the inside of the shell.
If you have a neck with a heel already cut for your flange profile, THAT will dictate where you need to drill.

RSS

© 2020   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service