FRETS.NET

Greetings,

I purchased a whole bunch of 3M sandpaper with the "no slip" backing. Most of my sandpapering (is that a word?) is done by gluing the sandpaper to a sanding block with rubber cement. I found that the no slip stuff cannot be glued to a sanding block. Must be wax or something similar, so now I have a whole bunch of f#*king sandpaper that I cannot use. Does anyone know what I could use to remove this stuff?

Thank You Folks

Views: 467

Reply to This

Replies to This Discussion

Iron it

OK I'll try that. Thanks

"Sanding".

That didn't seem to work. Thanks for your reply.

Instead of "sandpapering". I thought I should beat the previous two word reply ;-)

RSS

© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service