Robbie Collins
  • Male
  • Atlanta, GA
  • United States
Share on Facebook MySpace

Robbie Collins's Friends

  • John Lambdin
  • J R Emmett
  • Hesh Breakstone
  • Kerry Krishna
  • Paul Verticchio

Robbie Collins's Discussions

Which 3M Filter Cartridge?
1 Reply

I use the 3M 7503 Half Mask Respirator with a face shield when spraying lacquer. I am using 3M 60923 filter cartridges (pink & yellow). This is a P100 particulate filter that also protects…Continue

Started this discussion. Last reply by Glen H Apr 21, 2017.

New Tremolo - Hide glue instead of springs
8 Replies

Nothing like wood for tone.

Started this discussion. Last reply by Robbie Collins Mar 10, 2017.

1997 V-Series Strat - Bridge Splays Strings Too Widely?
24 Replies

This guitar just came in with an action complaint. It is a '57 Vintage Reissue. The action is fine, but playing it revealed that bending strings on the high E, especially above the 12th fret, causes…Continue

Started this discussion. Last reply by Walter W Wright May 4, 2017.

Manual Hand Drill Suggestions
5 Replies

I need a manual hand drill for drilling side dots. Can anyone suggest a quality tool?Continue

Started this discussion. Last reply by David Farmer Jan 6, 2017.


Robbie Collins's Page

Profile Information

Comment Wall (3 comments)

At 2:07am on June 6, 2013, Kerry Krishna said…

Robbie,I only collect the 1920s/30s two point guitars, mandos mandocellos,mandolas and tenors. Banjos are right out! Thanks for thinking of me though...

At 4:39pm on October 21, 2013, Frank Ford said…

Robbie   -

Sorry about your difficulty.  I've had that happen a few times on other forums myself, but I've presumed it had something to do with timing out or an action I took but didn't notice.  Haven't had other reports on FRETS.NET, but I wouldn't be too surprised if others have, because it's a kinda bare bones thing (cost, you know).  When I got started with NING, I had a pal working there so I had special access to support.  

At 8:54pm on May 9, 2014, Mark Stevens said…

I have taken over Dan Armstrong guitars! I need to at least know how to spot good or poor quality new fret work. Got Erlewine's Basic Fret Work DVD. It seem to focus on repairing frets. Did not get a good understanding how to do quick quality work.

You need to be a member of FRETS.NET to add comments!



© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service