FRETS.NET

Frank Ford's Discussions (941)

Search Forum

View

Discussions Replied To (924) Replies Latest Activity

"Just to be contrary, I suggest you NOT remove the neck! This kind of repair is much…"

Frank Ford replied Apr 2, 2009 to Martin body cracked along fingerboard, one side only

 12 Apr 3, 2009
Reply by David Houchens

"By all means, do convert to pin bridge. We used to do those old Harmony Sovereigns a…"

Frank Ford replied Mar 28, 2009 to Converting a backloading bridge to a pin bridge

 3 Mar 28, 2009
Reply by Frank Ford

"Well, there's no question about the bridge - it has to go. Bridgeplate should get a…"

Frank Ford replied Mar 23, 2009 to ADVISE PLEASE!

 26 Apr 10, 2009
Reply by Ned Knepp

"Removing the back is far less of a problem than taking off the top, presuming that i…"

Frank Ford replied Mar 17, 2009 to 1971 D-41 Martin that was scalloped too much.

 5 Mar 19, 2009
Reply by Steve Frost

"Here's a way to go - ENCO has a great deal on granite surface plates. (www.use-enco…"

Frank Ford replied Mar 7, 2009 to Granite Sanding Slab

 15 May 7, 2009
Reply by Frank Medina

"I've seen it done two ways. You can actually cut the appropriate checking lines with…"

Frank Ford replied Mar 6, 2009 to replicating an old finish on a new guitar

 6 Mar 6, 2009
Reply by Mark Dobbins

"It's been my experience that the Titebond regluing of pickguards depends on there be…"

Frank Ford replied Feb 19, 2009 to What did you say about re-attaching pickguards to bare wood?

 6 Feb 19, 2009
Reply by Frank Ford

"Best thing is to call his phone: 978-369-3359 You'll probably get a message suggest…"

Frank Ford replied Feb 16, 2009 to where to get bar fret wire

 11 Feb 16, 2009
Reply by Frank Ford

"I couldn't guess on the price, but you might well be able to get a Gibson tailpiece…"

Frank Ford replied Feb 15, 2009 to Lookin For A Replacement Tailpiece

 5 Mar 14, 2009
Reply by Michael Breid

"French polishing is usually done with an oil (nut, linseed, olive, etc.) along with…"

Frank Ford replied Jan 13, 2009 to Spraying versus french polishing

 20 Jan 16, 2009
Reply by Bob Webster

RSS

Members

© 2025   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service