FRETS.NET

Tim Mace's Discussions (308)

Search Forum

View

Discussions Replied To (301) Replies Latest Activity

"I think this could be due to the tap tone of your sound/board/box...you mentioned in…"

Tim Mace replied Jan 23, 2009 to Wolf tone/dead note question?

 12 Jan 24, 2009
Reply by Bob Webster

"I'm not so sure about using med gauge strings on Martins w/o adjustable truss rods p…"

Tim Mace replied Jan 6, 2009 to How can I easily fix a slightly overset neck?

 10 Jan 18, 2009
Reply by Ron Frazier

"I use shims & a drop or three of CA under the nut til' I get a combination that…"

Tim Mace replied Dec 6, 2008 to mandolin nut spacing

 17 Dec 19, 2008
Reply by Donald A. Fortune

"I've been thinking a gentle incline on the neck block to match the neck angle could…"

Tim Mace replied Nov 15, 2008 to Neck Angle Geometry

 15 Nov 15, 2008
Reply by Tim Mace

"heat bend/shape?"

Tim Mace replied Nov 15, 2008 to L5½-S Progress

 10 Jun 16, 2009
Reply by Donald A. Fortune

"The best advice I've read was about taking those frets down so they are out of the w…"

Tim Mace replied Nov 12, 2008 to Neck Angle Geometry

 15 Nov 15, 2008
Reply by Tim Mace

"These are flat top mandos and the arch/band will serve as brace.I know I'm pushin th…"

Tim Mace replied Nov 12, 2008 to Induced curve idea?

 11 Nov 15, 2008
Reply by Rick Homan

"I'm thinking arch,a little more than typical and ovang is mighty rigid... Somebody s…"

Tim Mace replied Nov 11, 2008 to Induced curve idea?

 11 Nov 15, 2008
Reply by Rick Homan

"Are those sides oak?"

Tim Mace replied Nov 11, 2008 to Dealing with water damage on an old parlor guitar

 4 Nov 12, 2008
Reply by Rick Homan

"Ramirez had the bass side of the fingerboard lower near the sound hole ...probably t…"

Tim Mace replied Nov 11, 2008 to Neck Angle Geometry

 15 Nov 15, 2008
Reply by Tim Mace

RSS

Members

© 2025   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service