FRETS.NET

All Discussions Tagged 'steam' (6)

Discussions Replies Latest Activity

Templates or guides for drilling steam holes

Since drilling holes in fretboards to steam necks off is such a common occurrence, are there templates with hole placements, or a list of p…

Started by Bruce Erickson

1 Sep 3, 2018
Reply by Mike Kolb

Order of operations for a Guild neck removal

So, I picked up another project. This one is a Guild D35 from 1982, which suffered a shattered neck and some really, really bad epoxy and c…

Started by Mark Pollock

7 Oct 11, 2012
Reply by Ian Barker

My neck reset/removal tips for general consumption. Approach with caution.

Some of these are copied from others, some I used my own pea-brain to figure out. After reading a recent post about a difficult neck remova…

Started by Mark A. Kane

7 May 13, 2011
Reply by Pierre-Antoine Roiron

neck reset on 60's Harmony flatop

Hi gents, I'm a French beginner amateur luthier and need to reset the neck of a H165 (all mahogany). My problem is that when I drilled the…

Started by Jeff Berdollt

11 Oct 14, 2009
Reply by Jeff Berdollt

Correcting "rising tongue" on a 1966 Precision Bass before refret

Hi all, this is my debut post on this very helpful forum and this may well have been discussed before in detail; if so, I'd appreciate it i…

Started by Bill Rodrick

6 Sep 3, 2009
Reply by Robert May

Frank Ford's Espresso Neck-Steaming Rig with Krups Model Numbers

Howdy All :) I just thought I'd share my copy of Frank Ford's Neck Steaming tip that is located here from ack in year 2000: http://frets.c

Started by Dan Gibbs

7 May 6, 2009
Reply by Larry Parker

RSS

© 2019   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service