Just received a Micro Mesh set and would like to get some insight on how to properly maintain their surfaces.  I see what not to use and understand that.  The warning not to saturate in water too much.

But of the acceptable cleaning materials, they are only listed.  Not explained is how to properly use them.

So, anything you can share would be very helpful.

Views: 256

Reply to This

Replies to This Discussion

I buy the large squares. I cut them up and divide the pieces into separate jobs sets. Finish, frets, bone, and dark wood.

After a few uses, I usually wash them in mild soapy water just to clean-out any build-up, then rinse in clear warm water and let them dry out at room temperature.  They seem to last a long time that way.


© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service