Travis Bean Pickup - replacement?
I have been working on assembling a Travis Bean TB1000. I hit a dead at pick ups. The last one I saw go on Ebay was $1500! I am looking for something that roughly measures the same size. 3" x 3+3/16" x 5/8" I am looking for anything to uae as a stop gap until originals can be found/afforded. A Fender Humbucker came to mind. Does anyone have one handy to measure? I am sure fabrication will be needed. The TB's mount from the rear.
Here are some photos:
http://www.monsterguitar.net/travis_bean.htm
Here are some photos:
http://www.monsterguitar.net/travis_bean.htm
Views: 503
Replies to This Discussion
-
Permalink Reply by Tom Krebs on
-
Sorry about that poor post. The cavity measurement should read: 2 X 3-3/16 X 5/8 inches. Long shot, but looking for pickups to fit?
-
Permalink Reply by Mac Walker on
-
Sweet project!!!!
As far as making a reproduction pickup, I suspect that this guy could probably help you out:
http://www.electricalguitarcompany.com/index.php/fuseaction/contact...
Don't know him at all but he is obviously into Travis Bean guitars. I'd be willing to bet you could actually buy a pickup from him that would fit this guitar....
© 2024 Created by Frank Ford.
Powered by
