Vintage Gibson pickguard removal.
Got an early 6o's LG that has the picjguard curl which has caused 3 separate cracks in the top...Problem is , VERY thin guard , finished over with NO separations...No gaps anywhere...I'm worried about opening a gigantic can of worms..
Views: 165
Replies to This Discussion
-
Permalink Reply by Greg Mirken on
-
If there’s no separation to work with I usually start at the point. Is that the sort of info you’re looking for?
Greg Mirken
-
Permalink Reply by thefishinmusician on
-
Not sure...I've taken lots off that had an access corner..But it's so thin and covered in finish...
-
-
If there’s already a crack under the E or B string you could start there. If you leave a mark it would be easier to hide than at the outer edge, say.
-
-
Good advice....
-
-
Gang....I balled up , as they say....Took out the magnifiers...Used some different low heating methods...TOOK MY TIME.....MOSTLY clean dismount...Able to save original gaurd...It WAS a bitch...Got the cracks taken care of and glued back on the braces...
© 2024 Created by Frank Ford.
Powered by
