FRETS.NET

I'm re-shaping neck of a Taylor 314CE and would like to know how much wood I have between the back of the neck and the truss rod. Saw the Taylor neck cutaway on Frets.com but not sure if the 314 would be the same. 

Thanks!

Views: 203

Reply to This

Replies to This Discussion

Test reply

I’d recommend against doing this. Hard to believe you find a Taylor neck too bulky.

I have found that X ray businesses can be willing to take a shot or two , its worth asking .

I believe all Taylor necks are of similar profile - so the example that you have seen in cross-section is probably very similar to the one on your bench.  As Greg suggested, Taylors have among the slimmest neck profiles of all acoustic makes.  I think you would want to be very cautious taking a Taylor neck any thinner. 

RSS

© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service