Forum Discussions (4,417)
| Discussions | Replies | Latest Activity |
|---|---|---|
How do you perform Kerfed Lining reglueI just found an old yamaha red label 12 string and the kerfed lining has broken off from the top of the guitar throughout the entire lower… Started by Matt Haugen in Luthier Talk |
1 |
Jul 17, 2009 Reply by Antonio Cotichini |
Newbie greetings....and a question about glue.Hello everyone. I'm new here and somewhat new to guitar/bass repair work. I'm working on some cheap old junkers to cut my teeth while absor… Started by John Cartwright in Luthier Talk |
5 |
Jul 16, 2009 Reply by John Cartwright |
Clear pick guard attachmentI have just been reading Franks guide to attaching a clear pick guard using the water method. I have been asked to fit one onto a new guita… Started by steve spearing in Luthier Talk |
8 |
Jul 15, 2009 Reply by steve spearing |
MandolinettoHi, I have a Mandolinetto that I listed on ebay yesterday. A couple of fellow instrument enthusiasts have sent me messages saying I should… Started by Sunny Cooper in Luthier Talk |
3 |
Jul 14, 2009 Reply by Antonio Cotichini |
The Kentucky MIJ MandolinsI have a 1980's KM-850 Bought on Ebay.Fantastic wood & workmanship-almost mint-which brings me to the problem.I think it has hardly bee… Started by mike carne in Luthier Talk |
20 |
Jul 13, 2009 Reply by mike carne |
Nasty headstock break on OME Banjo - Any advice?This is the worst break I've seen. In addition to the normal break thru the volute, the headstock veneer is separated for about 1/2 in. on… Started by Bill Langsdorf in Luthier Talk |
4 |
Jul 13, 2009 Reply by Bill Langsdorf |
Looking for a Gibson pickguard....I'll tell the embarrassing story on myself: While doing a neck reset on an older Gibson acoustic, I was pre-heating the neck joint area wit… Started by Mike Kolb in Luthier Talk |
8 |
Jul 12, 2009 Reply by Mike Kolb |
Builders with mahogany topsThe saga goes on and I'm still trying to "spend down" my parts box. While looking over all the sheet goods I noticed that I had sufficient… Started by Rob Mercure in Luthier Talk |
6 |
Jul 12, 2009 Reply by Tim Mace |
Is This Saddle Bone, or What?I bought a used guitar and this is the saddle that was installed. It is to be replaced because it's too short and the top doesn't have the… Started by Brent Hutto in Luthier Talk |
11 |
Jul 12, 2009 Reply by Tim Mace |
Gluing Ebony to Goncalo AlvesI will be needing to glue an ebony fretboard to a Goncalo Alves neck blank in the near future. Would hide glue be a good choice? Folks on M… Started by Michael Polutta in Luthier Talk |
5 |
Jul 9, 2009 Reply by Paul Hostetter |
© 2025 Created by Frank Ford.
Powered by
