FRETS.NET

I have a Norman ST 40 with a Tusq or Micarta saddle that I need to shim. Any ideas about what type of material to use?

Views: 347

Reply to This

Replies to This Discussion

I'm sure you'll get several different opinions on this. As an old friend of mine had a saying, "There are 2 schools of thought on this and I haven't been to either one." I've tried putting several kinds of shims under saddles in the past. I've discovered toothpicks, bubble gum wrappers, playing cards, and other things stuffed under the saddles. Lately, I've been using a shim made of the same material as the saddle, attached to it with CA glue. Thinning the shim to an acceptable height is the key. This seems to work better for me than just laying a piece of wood in the slot under the saddle. I feel using the same material lessens the chance of changing the tone.
Ronnie Nichols
Did you get the neck joint solid?

Those tend to have low bridges and shallow saddle slots, so I agree that gluing the shim to the bottom of the saddle is the way to go. Otherwise the saddle will be prone to leaning forward. Flatten the saddle bottom by rubbing on a piece of sandpaper and glue on a piece of rosewood or ebony veneer w/ medium thick cyano.
Yes, thanks, the neck joint is solid. I appreciate the heads up on the bolts. They weren't stripped after all.

Thanks to you both for the info on the shim.
I use Corian for most of my saddles and nuts...After 40 years of rock and/or roll I really can't hear a big enough difference to bone....Works well, polishes good,. and you can get free matereal for the asking....I make a pile of skinny shims when I put a new blade on my bandsaw...Eyeball a bunch of skinny cuts and you have a bunch of different thicknessed shims that are hard and workable...
It's probably simpler to make a new saddle out of bone. Bone blanks are cheap, or you can use micarta blanks if you like, they aren't expensive either.
If you have a shallow saddle slot, that is what I would do.
Jim
If you use Micarta, your local countertop joint throws away enough scrap to stock you for yrs , of course if you live out in the sticks like Jim it might be hard to find a countertop fabricater
I like to use the plastic packaging material that tools, toys and electronic gadgets come in. I keep a pile of the various thicknesses that I find and cut the shims with a paper cutter for accuracy of width. you can stack them to the desired height and glue them together and to the saddle if you like. Leaving them loose however offers the opportunity to fine tune later if you choose.

I look at it as a way of getting some good out of this packaging material that is frustrating to open, not to mention downright dangerous. I'm alway cutting myself on it or the knife I'm using to hack my way into the package.

Jerry
Jerry, I call that sort of packaging "consumer proof" packaging.

This isn't as dense as bone, does it effect the tone of the guitar?

Ned
Thanks for all the replies and info. What a helpful group! I bought one of Bob Colosi's shim kits. I'll let you know how it turns out.

RSS

© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service