FRETS.NET

In the shop today with an old Harmony with a very flaky finish. Trying to devise ways to protect the top while refretting and so on, but haven't managed to come up with anything really satisfactory. I'm loathe to stick anything to the to with tape etc. as the finish will come away when unstuck. What approach do the rest of you take?

Views: 328

Reply to This

Replies to This Discussion

I wrap mine in a plastic bin liner and then cover in card cut from a cardboard box. No problems with that so far.

know any drummers? 

old drumheads make great guitar top shields once trimmed to shape, especially the single-ply floor tom and kick drum bottom heads. they're tough, thin mylar.

I use kitchen cutting mats from Walmart. They come in packs of 3 for a couple of bucks a piece. I lay one under the guitar, draw around the shoulders, trim with scissors, and use low tack tape to hold in place. I label them with sharpies for reuse.

https://www.walmart.com/ip/Color-Flexible-Cutting-Mat/20531370

For fret work, I have been using the same piece of pickguard plastic over a decade. I avoid tape whenever possible.

RSS

© 2024   Created by Frank Ford.   Powered by

Badges  |  Report an Issue  |  Terms of Service